Hi,
I trying to get Xwindows on Debian Sarge 3.1r0a working on a Dell
desktop and LCD 19"(I think) monitor. The Graphics chip is 82865G with
shared memory, I think :-(. The display is a Dell 2001FP with AGP. I
went throught the install and selected a few different resolutions and
got the following error.
(EE) I810(0): No video BIOS modes for chosen depth.
(EE) Screen(s) found, but none have a usable configuration.
I reduced the bit depth from 24 to 16 and now it is running at 640x480
and 16 bit according to xwininfo.
I ran xvinfo and it reports 1440x 1080 max depth 16.
I tried to run base-config again but I can't find the part that
configures X but I didn't move /etc/X11/XF86Config-4 aside first.
I started to run dpkg-reconfigure xfree86-xserver and stopped because it
was much more difficult than the install program.
I'd like to start from the installer config as I figure I might have
selected something wrong such as sane pixels and bit depths.
I'm not sure what the program is in Sarge however.
Also I don't understand LCDs well: do they only do a couple of
resolutions such as the 640x480 and the 1440x1080? Other people have
this setup running windows so I could see what there system will do.
Since this is a shared memory graphics, do I need to do something
special? It reported 206844KB available. What does this mean?
Any insight and help would be appreciated.
Eric
---------------------------------------------------
PLUG-discuss mailing list -
PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
(text/plain)