On 2014-06-19 14:42,
joe@actionline.com wrote:
> Bob Elzer wrote:
>> Press the GO Button five times within four seconds
>> to see the wireless settings
> Thanks Bob. That was new info that I had not found
> or seen any other place,
> Network Name (SSID) SETUP
> Communication Mode Ad-hoc
This was in one of the JPEGs you posted earlier.
> However, it doesn't seem to be correct because my system
> Network Name (SSID) is "upquick" (not SETUP) ...
> And I still don't know how to get wireless to work.
I DuckDuckGoed "Brother HL2270-DW manual" and read chapter 3. As far
as I can tell from that, you can plug the printer in to a wired network,
find its IP address, then use a browser to go to
http://192.168.0.whatever/ and use the web-based administration tool to
tell the printer to use ESSID "upquick" and the password for your
network. The web-based administration tool is not documented in the
fine manual though.
Chapter 3 also says some stuff about using "wi-fi protected setup"
which may also be a possibility--not sure.
--
Crow202 Blog:
http://crow202.org/wordpress
There is no Darkness in Eternity
But only Light too dim for us to see.
---------------------------------------------------
PLUG-discuss mailing list -
PLUG-discuss@lists.phxlinux.org
To subscribe, unsubscribe, or to change your mail settings:
http://lists.phxlinux.org/mailman/listinfo/plug-discuss
(text/plain)