On 2014-06-19 14:42, joe@actionline.com wrote:
> Bob Elzer wrote:
>> Press the GO Button five times within four seconds
>> to see the wireless settings
> Thanks Bob.  That was new info that I had not found
> or seen any other place,
> Network Name (SSID)     SETUP
> Communication Mode      Ad-hoc

This was in one of the JPEGs you posted earlier.

> However, it doesn't seem to be correct because my system
> Network Name (SSID) is "upquick" (not SETUP) ...
> And I still don't know how to get wireless to work.

I DuckDuckGoed "Brother HL2270-DW manual" and read chapter 3.  As far 
as I can tell from that, you can plug the printer in to a wired network, 
find its IP address, then use a browser to go to 
http://192.168.0.whatever/ and use the web-based administration tool to 
tell the printer to use ESSID "upquick" and the password for your 
network.  The web-based administration tool is not documented in the 
fine manual though.

Chapter 3 also says some stuff about using "wi-fi protected setup" 
which may also be a possibility--not sure.

-- 
Crow202 Blog: http://crow202.org/wordpress
There is no Darkness in Eternity
But only Light too dim for us to see.
---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org
To subscribe, unsubscribe, or to change your mail settings:
http://lists.phxlinux.org/mailman/listinfo/plug-discuss