1. I installed a new nic, an asus NX1101, and went into the bios and
disabled the on board network interface controller. The system booted, but
the network was not working.
2. I then edited the /etc/network/interfaces file and changed eth0 to eth1
for the new nic. I then ran ifup eth1, and the network came up. I could
ping google.com and ssh to the box.
3. I rebooted the machine, and the boot process again stopped at
Configuring the network. I rebooted again to check if the bios had been
changed, and the bios still says that the on board network interface
controller is disabled.
So now the new nic is enabled, but the system still hangs at trying to
configure the network.
Anyone have any ideas?
Thanks,
Mark
On Sun, Jan 27, 2013 at 12:04 PM, Matt Graham <
danceswithcrows@usa.net>wrote:
> From: Mark Phillips <mark@phillipsmarketing.biz>
> > There was an ATI Rage 128 video card in the system, and the the newer
> > Debians do not have the radeon drivers.
>
> That shouldn't have caused any problems. Rage 128 cards use the r128 X
> module, not the radeon one. Why is Debian not including the radeon
> modules?
> That just seems weird and counterproductive, since so many machines out
> there
> have video cards driven by that module. And if it's headless, it should
> probably be starting up without X, in a VGA text console or vesafb, so that
> the video card is completely irrelevant.
>
> > However, the system hangs when trying to start network services.
> > [10.184481] e1000: eth0 NIC Link is UP 1000 Mbps Full Duplex, Flow
> > Control: RX/TX
> > [10.187930] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
> >
> > Then nothing is printed out and the system does not respond.
> > The card is the internal NIC - I don't have any extra cards in the
> > machine.
>
> Take a random PCI NIC you have lying around. Put that NIC in the machine.
> Go
> into the machine's BIOS Setup and disable the internal NIC. If you do
> that,
> and the thing boots normally, then the machine's internal NIC is hosed.
> BTDT.
> NIC failure *can* happen, it's just sort of rare since there aren't any
> moving parts.
>
> Or the new kernel has some sort of weird bug with its e1000 module. Distro
> kernels seem to have more weird bugs than vanilla kernels, for some reason.
> You could test this by booting with the rescue system's option for "no
> network", then if it comes up, and you modprobe e1000 and it immediately
> locks
> up, that may be the problem.
>
> --
> Matt G / Dances With Crows
> The Crow202 Blog: http://crow202.org/wordpress/
> There is no Darkness in Eternity/But only Light too dim for us to see
>
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org
> To subscribe, unsubscribe, or to change your mail settings:
> http://lists.phxlinux.org/mailman/listinfo/plug-discuss
>
---------------------------------------------------
PLUG-discuss mailing list -
PLUG-discuss@lists.phxlinux.org
To subscribe, unsubscribe, or to change your mail settings:
http://lists.phxlinux.org/mailman/listinfo/plug-discuss
(text/plain)