It looks like to me that it is configured properly. The only thing I can
think of is that you are pinging something out side of that network and
the gateway is only on port2.
On Fri, 2007-01-19 at 10:25 -0700, Nathan Aubrey wrote:
> On Friday 19 January 2007 10:22, you wrote:
> > On Fri, 2007-01-19 at 10:08 -0700, Nathan Aubrey wrote:
> > > All,
> > >
> > > I have a new server which has a broadcom netxtreme II nic with dual
> > > ports. The ports are numbered physically on the box port1 and port2
> > > eth0 = port2
> > >
> > > I assumed eth1 = port1
> > > But when I assign each an IP address, both addresses are only visible
> > > through port 2.
> > > I hope this makes sense.
> > >
> > > port 1 = 10.0.1.75
> > > port 2 = 10.0.1.9
> > >
> > > I only plug a network cable into port 2
> > > I can ping both IP addresses. If I plug a cable into port 1 I cannot ping
> > > anything.
> > >
> > > This is a Dell PowerEdge with the TCP/IP Offload system, which is
> > > dis-abled. I am not familiar with offload engine, is the other port only
> > > used with this system?
> > >
> > > I assumed the dual nic interface just meant I could use each interface
> > > uniquely... Am I wrong? I typically use dual nics, but wanted to try this
> > > one.
> >
> > ----
> > what is output of ifconfig?
> >
> > Craig
>
>
> eth0 Link encap:Ethernet HWaddr 00:18:8B:74:A3:B5
> inet addr:10.0.1.9 Bcast:10.0.1.255 Mask:255.255.255.0
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:388 errors:0 dropped:0 overruns:0 frame:0
> TX packets:202 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:41375 (40.4 Kb) TX bytes:30067 (29.3 Kb)
> Interrupt:16 Memory:f4000000-f4011100
>
> eth1 Link encap:Ethernet HWaddr 00:18:8B:74:A3:B3
> inet addr:10.0.1.75 Bcast:10.255.255.255 Mask:255.0.0.0
> UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> RX packets:80 errors:0 dropped:0 overruns:0 frame:0
> TX packets:1 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:7204 (7.0 Kb) TX bytes:64 (64.0 b)
> Interrupt:16 Memory:f8000000-f8011100
>
> lo Link encap:Local Loopback
> inet addr:127.0.0.1 Mask:255.0.0.0
> UP LOOPBACK RUNNING MTU:16436 Metric:1
> RX packets:269 errors:0 dropped:0 overruns:0 frame:0
> TX packets:269 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:0
> RX bytes:30288 (29.5 Kb) TX bytes:30288 (29.5 Kb)
>
>
> I can ping both IP addresses with only eth0 plugged in.
>
> nathan
---------------------------------------------------
PLUG-discuss mailing list -
PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
(text/plain)