Here's the setup for wiring a RJ-45 to db-9/db25 module using a straight
network cable (NOT the Cisco roll over cable):
RJ-45 DB-9 DB-25
----- ---- -----
1 8 5 RTS
2 6 6 DSR
3 2 3 RxD
4 GND
5 5 7 GND
6 3 2 TxD
7 4 20 DTR
8 7 4 CTS
HTH, rna
On Fri, 10 Dec 2004, Scott Denlinger wrote:
> Hi everyone,
>
> I'm trying to make a console management cable for my Cisco uBR904 cable modem,
> since it didn't come with one when I bought it on eBay, and I'm wondering if
> anyone can help me with the pin-outs. It's a serial cable with RJ-45 on the
> modem end, and DE-9 on the computer end.
>
> In general I know you need to cross the TX and RECEIVE pins for serial
> connections, but do you need to do the same for DTR and DSR? Or does DSR on the
> cable modem connect to DSR on the computer's serial port, and DTR go to DTR?
> Should my pinouts go like this
>
> modem computer
> TX ---> REC
> REC ---> TX
> DTR ---> DTR
> DSR ---> DSR
>
>
> or like this?
>
> modem computer
> TX ---> REC
> REC ---> TX
> DTR ---> DSR
> DSR ---> DTR
>
> (note that I'm not necessarily indicating signal direction in the above, just
> connections)
>
> And perhaps a more general question: can I get this modem to work with Cox
> Internet service using just the factory defaults, or is there some specific way
> I need to configure the Cisco IOS for the modem to work. I bought it before I
> realized it wasn't on Cox's "supported modems" list, and perhaps there's a
> reason for that, but I'd like to solve the challenge of trying to get this to
> work. Based on my limited reading on this, it seems that Cox sends down a
> configuration file to whatever cable modem you've got hooked up, which doesn't
> match up with whatever specs the uBR904 is set for. (You can tell I have a lot
> to learn about all this!) I've Googled for the appropriate settings, but
> haven't had any luck finding useful info., so pointers to useful URLs or
> newsgroups would be appreciated.
>
> Thanks very much in advance.
>
> Scott Denlinger
> sbd@u.arizona.edu
>
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
> To subscribe, unsubscribe, or to change you mail settings:
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
>
---------------------------------------------------
PLUG-discuss mailing list -
PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
(text/plain)