I am trying to configure a flat panel Dell 17003FP monitor and according
to the documentation the monitor supports 1280x1024 64.0 kHz and
vertical 60.0 Hz or 1280x1024 Horiz 80 kHz and Vert 75 Hz
I was looking at the man page for XF86Config-4 and it says that usually
a range is entered in the config file, could I just put 80 kHz for the
Horiz and 75 Hz for the Vertical, or is a range required.
Of course those rates are only 1280x1024 which is the only resoltion I
am using, but should I enter the rate range for all resolutions from as
low to as high as the monitor supports under all resolutions supported?
Jim
---------------------------------------------------
PLUG-discuss mailing list -
PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
(text/plain)