On Sun, 16 Nov 2003, Marcia Wilbur wrote:
> Did you try sdb1? It looks like it should be sdb1. The number is the
> partition, the number defines the
> actual drive...
The letter defines the actual drive.
>
> Also, make sure you have the right usb modules loaded.
>
> I just got a Muvo and got it to work. I'm listening to it now. It rocks!
>
>
> -marcia
> On Mon, 10 Nov 2003, Jim wrote:
>
> > ect:
> > [Tfug] usb flash disc
> > I have tried to get my usb flash disc to work by making edits to /etc/fstab and
> > the problem is that I have not been able to determine where usb-storage is
> > loading the usb flash disc in. For example /dev/sda2 could be the usb flash
> > drive but I recieve the following error: /dev/sda2 is not a valid block
> > device
> >
> >
> > When I cat /proc/scsi/scsi I have the below output:
> > cat /proc/scsi/scsi
> > Attached devices:
> > Host: scsi0 Channel: 00 Id: 03 Lun: 00
> > Vendor: PLEXTOR Model: CD-ROM PX-40TS Rev: 1.05
> > Type: CD-ROM ANSI SCSI revision: 02
> > Host: scsi0 Channel: 00 Id: 04 Lun: 00
> > Vendor: PLEXTOR Model: CD-R PX-W1210S Rev: 1.05
> > Type: CD-ROM ANSI SCSI revision: 02
> > Host: scsi2 Channel: 00 Id: 00 Lun: 00
> > Vendor: USB Model: Flash Driver Rev: 1.11
> > Type: Direct-Access ANSI SCSI revision: 02
> >
> > When I run the following command when plugging in the flash disc "tail -f
> > /var/log/messages" I recieve the following:
> > kernel: usb.c: USB disconnect on device 00:07.3-1 address 2
> > kernel: hub.c: new USB device 00:07.3-1, assigned address 3
> >
> >
> >
> >
> > Jim
> >
> > ---------------------------------------------------
> > PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
> > To subscribe, unsubscribe, or to change you mail settings:
> > http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
> >
> >
>
(text/plain)