If I'm reading the site correctly using the -d switch means you are going to
point it to the device (-d, --device-name=DEVICE). Try using the -L switch and
see what it lists. Also check and see if you have /dev/scanner and if so what
it is pointed at.
"Robert N. Eaton" wrote:
>
> Hi all,
>
> Well, today I bit the bullet and went out and bought a new Adaptec 2906
> card.
>
> Linux seems to recognize the card. I/O port information:
>
> I/O-Range Used by
> de00-debe aic7xxx
>
> Bus 0 device 9 function 0
>
> SCSI storage controller Adaptec AIC 7850 (rev3).
> Medium devsel. Fast back to back capable. IRQ 11
> Master capable. Latency=64, MinGut(?)=4. Max lat=4
> IO at 0xde00 [0xde01]
>
> Device information says:
>
> SCSI Attached Devices:
>
> Host: SCSI0 channel : 00 ID : 04 Lun : 00
> Vendor: UMAX Model: Astra 1220s Rev: V1.3
> Type: Scanner ANSI SCSI revision : 02
>
> I can't get xscanimage to work, either at the commandline or by icon.
>
> scanimage -d gives me: scanimage: no SANE devices found .
>
> How do I get sane to recognize the scanner?
>
> Bob Eaton
>
> ________________________________________________
> See http://PLUG.phoenix.az.us/navigator-mail.shtml if your mail doesn't post to the list quickly and you use Netscape to write mail.
>
> Plug-discuss mailing list - Plug-discuss@lists.PLUG.phoenix.az.us
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
(text/plain)