*nix commands on windows

[Michael Butash]

Cygwin won't give you ifconfig or ip tools (didn't years back at least), 
it'll still be "ipconfig /all"

Look at the subnet mask there, should be 255.255.255.0.  If they're all 
on the same switch/router, than they're in the same subnet.

Can they ping each other's addresses?  layer 3 is good
Telnet to each other on port 445 "telnet 192.168.0.x 445"  layer 4 is good
 From windoze, "start->run-> type "\\192.168.0.x\" and see if you can 
see shares.  Try more specifically if you know the share name.

If you want to test from linux back install smbfs packages (specifically 
for cifs) and mount as:

mkdir /tmp/cifs
mount -t cifs -o defaults,username=myuser //192.168.0.x/share_name /tmp/cifs

Layer 5 and up should be good if you can do the last, otherwise figure 
out where in between the problem lies.  Try in both directions too. 
It's more than likely with samba config, not the network.  Though I'm 
not at all sure what that 5.5.6.1 address was you were looking at...

-mb


On 03/14/2012 05:10 PM, Michael Havens wrote:
> well, I figured I would d/l something so if you tell me how to do
> something in *nix I wouldn't have to ask you how to do it in windows. So
> I googled it and found 'cygwin'. so I install it and the first command I
> type in I am DENIED! File not found it says. So what is the best unix
> emulator for windows? 'ip addr show' is the command that wasn't found.
>
> --
> :-)~MIKE~(-:
>
>
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss at lists.plug.phoenix.az.us
> To subscribe, unsubscribe, or to change your mail settings:
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss