I tried smartctl. It reported that the apm data was unavailable. I
couldn't get it to stay on, so I came up with a workaround. I set up a
cron job with two commands. The first touches a file on that drive.
The second deletes it. I set this for 10 minutes and it s eems to be
working.
On 11/28/21 1:23 PM, AZ Pete via PLUG-discuss wrote:
> Hi,
> I have had the same problem with USB connected drives on my Pis, but I
> needed the reverse. Namely, I wanted them to spin down after some
> time. The bottom line is that since the hard drive is connected via
> USB, the USB hardware itself may prevent the drive from spinning down
> (or always shut it down). But, I've had some success using the
> smartmon tools package to control how/when a given hard drive will
> spin down. The package is called smartmon tools, but the command
> itself is smartctl. A few examples:
> sudo smartctl -a /dev/sda - display all info about drive
> sudo smartctl -g all /dev/sda - get all non-SMART settings
> (i.e. Advanced Power Mgmt setting)
> sudo smartctl --set=apm,127 - set Advanced Power Mgmt
> sudo smartctl --set=standby,241 - set standby timer to
> 30min (not sure if this superseded by apm setting)
>
> A low value means aggressive power management and a high value means
> better performance. Possible settings range from values 1 through 127
> (which permit spin-down), and values 128 through 254 (which do not
> permit spin-down). The highest degree of power management is attained
> with a setting of 1, and the highest I/O performance with a setting of
> 254. A value of 255 disables Advanced Power Management altogether on
> the drive (not all drives support disabling it, but most do).
>
> You'll have to dig into the man pages and play around with the various
> APM settings to see if you can get things to work as you like.
>
> If all else fails you could just set up a cron job which runs a script
> every minute that simply touches a file on the drive (i.e. touch
> /some_folder/some_dummy_file.txt), which should prevent it from
> spinning down.
>
> Hope this helps.
> Peter
>
>
>
> On 11/27/2021 9:00 PM, Jim via PLUG-discuss wrote:
>> I have a hard drive attached via a USB adapter to my raspberry pi.
>> The problem is that the disk always shuts down after a few minutes of
>> inactivity. When I want to access something on the disk or write to
>> it, I have to wait for it to spin up. How would I go about setting
>> it so it doesn't spin down? I tried to look online and found sdparm
>> mentioned, but found nothing I could understand. Please help. Thanks
>> ---------------------------------------------------
>> PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org
>> To subscribe, unsubscribe, or to change your mail settings:
>> https://lists.phxlinux.org/mailman/listinfo/plug-discuss
>
>
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org
> To subscribe, unsubscribe, or to change your mail settings:
> https://lists.phxlinux.org/mailman/listinfo/plug-discuss
---------------------------------------------------
PLUG-discuss mailing list -
PLUG-discuss@lists.phxlinux.org
To subscribe, unsubscribe, or to change your mail settings:
https://lists.phxlinux.org/mailman/listinfo/plug-discuss
(text/plain)