Kevin (and others of the list)
thanks for the suggestions. I've been told that this is very likely a
hard disk HEAD crash, which would make any data on the drive nearly
impossible to recover without spending $$$ to get at it (lowest price
I found so far was $499.00 and it would take a week). I can see now
why there is such big moeny in data recovery. I can do the software
stuff easily enough, but some hardware may be out of my reach (HD
sugery requires a class 100 clean room and I don't have $2 million to
invest). Now, I wouldn't mind working for one of more of these places.
they do tend to pay well and I could learn rather a lot.
On Wed, Apr 30, 2008 at 2:18 PM, Kevin Faulkner <
kondor6c@cox.net> wrote:
>
>
> > > > >
> > > > > does anyone happen to have a spare electronics package laying around
> > > > What do you mean by electronics package?? I hope your not just planning on
> > > > swapping the PCB (Printed Circuit Board or Primary Controller Board, it varies).
> > > > If you swap with the wrong one you could be worse off. When swapping those out
> > > > you need to be very precise with Western Digitals you need to be aware of the
> > > > Site Code as well as the top number/letter combo, i think with yours it might be
> > > > something like: AMR <number here> or AMK I don't remember something like that
> > > > though. I know what its like to loose data, keep us informed.
> > >
> > ok,
> > here the numbers I do have:
> >
> > S/N: WCANU1419620
> > WWN: 50014EE2AAB5FB6D
> > MDL: WD500ks-00MNB0
> > DCM: HCACAJAAB
> >
> > does any of this help?
> Really your on your own unless you have a buddy that has something very similar
> to your board. I would start looking at Ebay for those specs. At the place I
> used to work at we kept thousands of drives even if the head were bad, because
> then you could swipe the PCB from it.:w If you look around there are specific
> companies that cater to this situation and they have warehouses full of drives
> and they charge (easily) $400 for say an 80 gig drive.
> But keep in mind your not 100% sure that it really is the PCB, it could be that
> the heads are failing (which is probably more likely). What I think is happening
> is that when you power it on your heads are failing and its trying to initialize
> but it can't so it keeps on trying. Finally the BIOS just says "whatever man,
> I'm moving on" and the drive doesn't show up. Head swaps are hard to do. take
> the PCB off and visually inspect it, looking for any burn marks also smell too.
> good luck
> -kevin
>
>
>
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
> To subscribe, unsubscribe, or to change your mail settings:
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
>
---------------------------------------------------
PLUG-discuss mailing list -
PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change your mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
(text/plain)