I added a second hard drive to an older EIDE system, but I cannot get a
file system on it. This is not my primary drive, but a second drive.
Here is what I did:
1. Ran fdisk and wrote the following partition table:
spongebob:~# fdisk -l /dev/hdb
Disk /dev/hdb: 120.0 GB, 120034123776 bytes
255 heads, 63 sectors/track, 14593 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/hdb1 1 14593 117218241 85 Linux extended
spongebob:~#
2. I then tried to create a file system:
spongebob:~# mke2fs -cjv -L patrick /dev/hdb1
mke2fs 1.35 (28-Feb-2004)
/dev/hdb1: Invalid argument passed to ext2 library while setting up
superblock
spongebob:~#
I tried all sorts of parameter combinations and always get the same
error. I took out the '-L patrick'; I took out the 'v', I took out the
'c'. My final test:
spongebob:~# mke2fs -j /dev/hdb1
mke2fs 1.35 (28-Feb-2004)
/dev/hdb1: Invalid argument passed to ext2 library while setting up
superblock
spongebob:~#
So, what am I doing wrong?
Thanks!
Mark
---------------------------------------------------
PLUG-discuss mailing list -
PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss