lilo failed--HELP

"Michael J. Schweppe" wrote:
>
> >wow - I believe that when your /boot oartutuib is on the slave drive,
> >you have to include something like bios=0x82 in lilo.conf - you should
> >have seen a message flash by about this at the tail end of the install.
>
> Messages go by pretty fast, couldn't tell you...

drats... now I know that that information is sent to a file somewhere
so you can view it later... Just cannot recall of the top of my head
where...

Just checked. /var/log/boot.msg contains a bunch of stuff, but I
though there was more somewhere...

> To recap, on the initial install, after the second cd was placed I
> stepped out of the room for an extended period of time. This was a
> mistake because I missed the boot creation section, apparently Linux
> timed out and finished the install. Hence no boot disk on round one.

ahhh...

> After I got the fdisk /mbr sqaured away [I didn't know that after you
> issue the fdisk /mbr commmand that noting happens on the command line
> but that you reboot anyhow. OK, so I'm back in Win and reinstall Red
> Hat. Careful to pay close attention and make boot disk. Reboot.
> Blah. Same issue :-(. After reboot I get the usual power up stuff,
> and then a flashing "L" with a non-responsive system.
>
> Use boot disk to get Linux up.
>
> Here is a copy of my /etc/lilo.conf
>
> boot=/dev/hda
> map=/boot/map
> install=/boot/boot.b
> prompt
> timeout=50
> message=/boot/message
> linear
> default=dos
>

> image=/boot/vmlinux-2.4.2-2
>         label=linux
>         read-only
>         root=/dev/hdb8

I have:

image = /boot/vmlinuz_24
label = linux_2.4
root = /dev/hdb3
initrd = /boot/initrd_24
append = "hdc=ide-scsi hdd=ide-scsi"
optional

another entry for scsi drives:

image = /boot/vmlinuz
root = /dev/sda4
initrd=/boot/initrd
label = suse70
append = "hdc=ide-scsi hdd=ide-scsi"


The ide-scsi stuff is necessary only if you are going to try to run
Xcdroast (to burn CD's)

I remember something about initrd being required in certain cases...
Cannot remember which ones though.

Also the read-only tage you use here I have in the header which I have:

  boot    = /dev/fd0

  vga     = normal
  read-only
  menu-scheme = Wg:kw:Wg:Wg
  lba32
  prompt
  timeout = 80
  message = /boot/message
  default=linux_2.4

> other=/dev/hda1
>         optional
>         label=dos

For this I have:

other = /dev/hda1
label = nt
table = /dev/hda


Hope this helps...

EBo --

ps: you said that NT went on the second of two scsi drives. Did I hear
that correctly?