Speeding up File Transfers

I have SBB at Cooper and Elliot and here are the test results from the
DSLREPORTS link below.

Your download speed : 2089474 bps, or 2089 kbps.
Browsers would show : about a 255 k/sec transfer rate.
Your upload speed : 85892 bps, or 85 kbps.
Your connection rocks .. above the 1mbit barrier!

Donn

----- Original Message -----
From: "Craig White" <craigwhite@azapple.com>
To: <plug-discuss@lists.PLUG.phoenix.az.us>
Sent: Thursday, May 31, 2001 2:51 PM
Subject: RE: Speeding up File Transfers


> This may be of interest but I am quite happy with Sprint Broadband service
> myself and I have a bunch of customers that I have set up and they are
happy
> with it too...
> <http://www.zdnet.com/zdnn/stories/news/0,4586,2767061,00.html>
>
> and a speed test site...
> <http://www.dslreports.com/stest/0,>
>
> I think there are some misconceptions about Sprint Broadband.
>
> If you can download their test files are near rated speeds - this tests
the
> speed of your connection to Sprint and if it's working. I found that I
have
> twice had to pull the power cable not only on the broadband modem but also
> the antenna feed to the roof - it also has power requirements. This seem
to
> reset everything.
>
> As for Windows/Linux/Macintosh - it's all meaningless because it's the
> computer not the OS (yeah I suppose a poor OS or poor GUI performance can
> make it seem like the problem is the OS.
>
> I am in Scottsdale / zone II and performance has been quite good for a
long
> time now. I also noticed that their upstream speeds have significantly
> improved but yes, I am not likely to get more than 25 - 30 Kbps on the
> upstream on the best of days. (pulling email off my web based mail server
> while I was in California).
>
> Things to check before calling tech support (paths listed are RedHat -
YMMV)
>
> 1. Power cycle both router modem & box supplying feed to upstream co-ax on
> roof top dish.
>
> 2. /etc/sysconfig/network settings - default gateway is right and if you
use
> linux to masquerade internet connection to others, that
>
>
HOSTNAME="registered.with.dns.hostname_OR_cpe-your-ip-separated-by-dashes.az
> .sprintbbd.net"
> GATEWAY="your.gateway.ip.number"
> GATEWAYDEV="eth1" or whatever device is connected to Sprint
> FORWARD_IPV4=yes
>

> 3. /etc/sysconfig/network-scripts/ifcfg-eth0
>   &
>    /etc/sysconfig/network-scripts/ifcfg-eth1
>   etc
>   are all set up properly and that means not only ip address but subnet

mask
> too.
> If they want you to use less than a full class "C" (255.255.255.0) make
> sure
> that your subnet is correct.
>
> 4. Turn off unnecessary services - Interestingly enough - Redhat 7.1
> defaults to not autostarting most of the services on installation whereas
> earlier versions of RedHat started a whole bunch of services. Obviously,
> they were listening to der.Hans.
>
> Craig
>
> ----:----|----:----|----:----|----:----|----:----|----:----|
> - Craig White - PO Box 8634 - Scottsdale, Arizona - 85252
> - e-mail address ................ - CraigWhite@AzApple.com
> - world wide web address ........ - http://www.AzApple.com
> - e-mail my pager address ....... - 6023779752@airtouch.net
> - cellular phone ................ - (602) 377-9752
> - voice/facsimile ............... - (480) 945-8445
> ----:----|----:----|----:----|----:----|----:----|----:----|
>