On Nov 2, 12:23pm, Frank Reichenbacher wrote:
> RH 6.2 has the same feature, albeit with a few bugs. I tried to use it to
> upgrade the kernel and after it crunched away determining which updates were
> appropriate for my system, it came back with a message saying it was
> excluding the kernel rpms because I hadn't requested them. There is no way
> to select packages to upgrade in advance, so there is no way to use the
> update feature to upgrade the kernel.
I may be doing my employer a disservice by saying this, but I almost
never use the kernel that comes with the distribution. I usually
fetch the kernel sources and build it myself once the basic OS install
is done. (Okay, so I do run the distribution supplied kernel for just
long enough to build a new kernel myself.)
I recently upgraded one of my machines to RH7 and wound up not using
the kernel that shipped with RH7 *at all*. I had previously built
2.4.0-test9 on my RH6.2 install on the same box and had configured
software RAID for the new disks that I had just bought. I installed
RH7 on a free partition on one of these new disks, then rebooted into
6.2 and copied over the just completed install to one of the md
(raid-1) partitions. Once that was done, I updated lilo.conf to boot
RH7 with 2.4.0-test9. (And so on...)
Anyway... with regard to the problem that you mentioned, I think
there's a way to specify in advance which areas that you're interested
in. For some reason (though I don't know what it is), the default
is to exclude the kernel. Ah... I found it. The utility is called
up2date-config and there's a tab labeled "Package Exceptions". In
the box entitled "Package Names to Skip", there's an entry called
"kernel*". You may wish to remove this entry and try again.
Kevin
(text/plain)