Problem getting new kernel to boot

Did you copy the System.map?

>
> OK, first the setup. This is a PPro 200 with 128MB Ram. It has RH6.2 installed
> with the 2.2.16-3 kernel (precompiled rpm binary). I downloaded the tar.gz of
> 2.2.17, uncompressed it to /usr/src/linux-2.2.17. configured it, compiled it
> (no errors), moved the bzImage to /boot and edited /etc/lilo.conf to default to
> the new kernel, run lilo and reboot. Upon rebooting I get a kernel panic and a
> message that says to try to set init to something.
>
> At this point i try to reboot and at 'lilo:' type 'linux init=3'. Again kernel
> panics. I can get back into the system thanks to the previous kernel.
> Unfortunately the box is at school so I don't have the exact message. I'm
> stumped as to what to do. I looked in a couple of the books I have, but of
> course they don't mention much about kernel panics. Any suggestions?
>
> ________________________________________________
> See http://PLUG.phoenix.az.us/navigator-mail.shtml if your mail doesn't post to the list quickly and you use Netscape to write mail.
>
> Plug-discuss mailing list - Plug-discuss@lists.PLUG.phoenix.az.us
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
>