IDE vs SCSI drives

Top Page
Attachments:
Message as email
+ (text/plain)
Delete this message
Reply to this message
Author: KevinBuettnerkev@primenet.com
Date:  
Subject: IDE vs SCSI drives
On Oct 18, 9:28am, Craig White wrote:

> Perhaps someone will clue me in to what IIRC actually means.


IIRC == "If I Recall Correctly".

> My first thought was that you are comparing new IDE drive technology to 4
> year old SCSI technology.


The SCSI technology is a little over a year old. As I mentioned in
my reply to David, the SCSI drive runs at 7500 RPM and the IDE drives
only run at 5400 RPM.

> SOA of SCSI is ultra3 (160mbs) and ultra
> controller like the Adaptec 29160 and 10,000 - 15,000 WD ultra3 drive would
> probably dust the IDE's but you surely caught my attention with your post.


The SCSI controller is an Ultra2 which should be capable of 80MB/sec.
I didn't see anywhere close to that kind of performance though. (12.67
MB/sec for reads; 8.43 MB/sec for writes (copying from the kernel's
buffer cache.)

> Then there are hardware RAID controllers that should really optimize
> performance.


I know. When I purchased the IDE drives recently, I was shooting for
cheap and reliable (which is why I got two and am mirroring them) rather
than high performance. This is why I was amazed when these drives
performed better than my SCSI drive.

Also, it seems to me that with regard to performance you might be better
off just putting a boatload of memory in the box... eventually most of
the stuff that you read off of disk will be in the kernel's buffer cache.

> Also I don't seem to get the same reliability from IDE on servers that I get
> from SCSI - however most of my firsthand comes from Windows NT which seems
> to pretty well thrash an IDE drive in a years time.


I had the same concerns. I have very little direct experience with IDE,
but I've read dire warnings regarding IDE in a number of places. Again,
that's why I decided to get two IDE drives and mirror them.