How to set eth0 and eth1

[James Mcphee]

When you have the otg interface up, what is the result of standard OSI
model troubleshooting?

On Sat, Feb 14, 2015 at 1:56 PM, Carlton Brooks <linux at carltonbrooks.net>
wrote:

>  I have an Odroid UX-3. It contains an ethernet port as well as usb3 otg
> port.
>
> When I do a ifconfig the results show that I have an eth0 and an eth1.
> If I plug in my cat 6 to the ethernet plug it shows I have an eth0 ip of
> 192.168.1.101.
> If I remove the cat 6 from the traditional ethernet plug and then plug in
> the otg cable through a usb 3 gigabit ethernet adapter and then run
> ifconfig again it shows that I have an eth1 ip of 192.198.1.146.
>
> I can ssh into the traditional ethernet port if the cable is plugged in
> using the 192.68.1.101.
> If I use the otg setup I can not ssh into the 192.168.1.146.
>
> I went into the /etc/udev/rules.d/70-persistent-net.rules and changed the
> MAC address and the names of eth0 and eth1
>
> The settings changed as expected, but I still can not ssh into the otg
> setup.
>
> What can I do to make the otg eth0 and be able to ssh into it.
>
> Thanks for anyone who can guide me in the right direction.
>
> Carlton Brooks
>
>
>
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss at lists.phxlinux.org
> To subscribe, unsubscribe, or to change your mail settings:
> http://lists.phxlinux.org/mailman/listinfo/plug-discuss
>



-- 
James McPhee
jmcphe at gmail.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.phxlinux.org/pipermail/plug-discuss/attachments/20150215/42499892/attachment.html>