is my power supply dieing?
Michael
bmike1 at gmail.com
Thu Jul 16 13:41:37 MST 2020
Might the problem still be the he
On Thu, Jul 16, 2020 at 4:37 PM Stephen Partington via PLUG-discuss <
plug-discuss at lists.phxlinux.org> wrote:
> 68C under load is good. 80C+ idle is bad.
>
>
> On Thu, Jul 16, 2020 at 12:35 PM Michael via PLUG-discuss <
> plug-discuss at lists.phxlinux.org> wrote:
>
>> lets get back to heat... last time I was running glx (with the horse
>> and various other pictures) and watch, and stress ng the temp was like
>> 68. I don't think that is too bad.
>>
>> On Thu, Jul 16, 2020 at 3:19 PM Brian Cluff via PLUG-discuss
>> <plug-discuss at lists.phxlinux.org> wrote:
>> >
>> > Looks like your drive probably isn't the problem.
>> >
>> > Brian Cluff
>> >
>> > On 7/16/20 11:54 AM, Michael via PLUG-discuss wrote:
>> > > On Thu, Jul 16, 2020 at 3:37 AM Brian Cluff via PLUG-discuss
>> > > <plug-discuss at lists.phxlinux.org> wrote:
>> > >> Also check the health of your hard drive with smartctl. I've hard
>> > >> systems freeze on me because my hard drive was dying that then
>> appear to
>> > >> work again for a while after a reboot. Basically your drive starts
>> > >> throwing errors and eventually the system remounts it as read only
>> and
>> > >> your system eventually freaks out and freezes because it can't write
>> to
>> > >> the drive anymore.
>> > > I sure hope this is the problem. It'll give me an excuse to put an ssd
>> > > in the machine.
>> > > This is from live media boot. I'll see if I can freeze the system
>> > > again.... it did when I tried it before but it hasn't frozen for a
>> > > couple of days now.
>> > > sudo smartctl --all /dev/sda
>> > > smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-26-generic] (local
>> build)
>> > > Copyright (C) 2002-19, Bruce Allen, Christian Franke,
>> www.smartmontools.org
>> > >
>> > > === START OF INFORMATION SECTION ===
>> > > Model Family: Western Digital Caviar Blue (SATA)
>> > > Device Model: WDC WD3200AAKS-75L9A0
>> > > Serial Number: WD-WMAV2S110171
>> > > LU WWN Device Id: 5 0014ee 057775228
>> > > Firmware Version: 02.03E02
>> > > User Capacity: 320,072,933,376 bytes [320 GB]
>> > > Sector Size: 512 bytes logical/physical
>> > > Device is: In smartctl database [for details use: -P show]
>> > > ATA Version is: ATA8-ACS (minor revision not indicated)
>> > > SATA Version is: SATA 2.5, 3.0 Gb/s
>> > > Local Time is: Thu Jul 16 18:33:20 2020 UTC
>> > > SMART support is: Available - device has SMART capability.
>> > > SMART support is: Enabled
>> > >
>> > > === START OF READ SMART DATA SECTION ===
>> > > SMART overall-health self-assessment test result: PASSED
>> > >
>> > > General SMART Values:
>> > > Offline data collection status: (0x84) Offline data collection
>> activity
>> > > was suspended by an interrupting command from
>> host.
>> > > Auto Offline Data Collection: Enabled.
>> > > Self-test execution status: ( 0) The previous self-test
>> > > routine completed
>> > > without error or no self-test has ever
>> > > been run.
>> > > Total time to complete Offline
>> > > data collection: ( 6000) seconds.
>> > > Offline data collection
>> > > capabilities: (0x7b) SMART execute Offline immediate.
>> > > Auto Offline data collection on/off support.
>> > > Suspend Offline collection upon new
>> > > command.
>> > > Offline surface scan supported.
>> > > Self-test supported.
>> > > Conveyance Self-test supported.
>> > > Selective Self-test supported.
>> > > SMART capabilities: (0x0003) Saves SMART data before
>> entering
>> > > power-saving mode.
>> > > Supports SMART auto save timer.
>> > > Error logging capability: (0x01) Error logging supported.
>> > > General Purpose Logging supported.
>> > > Short self-test routine
>> > > recommended polling time: ( 2) minutes.
>> > > Extended self-test routine
>> > > recommended polling time: ( 73) minutes.
>> > > Conveyance self-test routine
>> > > recommended polling time: ( 5) minutes.
>> > > SCT capabilities: (0x3037) SCT Status supported.
>> > > SCT Feature Control supported.
>> > > SCT Data Table supported.
>> > >
>> > > SMART Attributes Data Structure revision number: 16
>> > > Vendor Specific SMART Attributes with Thresholds:
>> > > ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE
>> > > UPDATED WHEN_FAILED RAW_VALUE
>> > > 1 Raw_Read_Error_Rate 0x002f 200 200 051 Pre-fail
>> > > Always - 0
>> > > 3 Spin_Up_Time 0x0027 138 133 021 Pre-fail
>> > > Always - 4075
>> > > 4 Start_Stop_Count 0x0032 089 089 000 Old_age
>> > > Always - 11090
>> > > 5 Reallocated_Sector_Ct 0x0033 200 200 140 Pre-fail
>> > > Always - 0
>> > > 7 Seek_Error_Rate 0x002e 100 253 000 Old_age
>> > > Always - 0
>> > > 9 Power_On_Hours 0x0032 019 019 000 Old_age
>> > > Always - 59593
>> > > 10 Spin_Retry_Count 0x0032 100 100 000 Old_age
>> > > Always - 0
>> > > 11 Calibration_Retry_Count 0x0032 100 100 000 Old_age
>> > > Always - 0
>> > > 12 Power_Cycle_Count 0x0032 098 098 000 Old_age
>> > > Always - 2282
>> > > 192 Power-Off_Retract_Count 0x0032 199 199 000 Old_age
>> > > Always - 1044
>> > > 193 Load_Cycle_Count 0x0032 197 197 000 Old_age
>> > > Always - 11090
>> > > 194 Temperature_Celsius 0x0022 105 080 000 Old_age
>> > > Always - 38
>> > > 196 Reallocated_Event_Count 0x0032 200 200 000 Old_age
>> > > Always - 0
>> > > 197 Current_Pending_Sector 0x0032 200 200 000 Old_age
>> > > Always - 0
>> > > 198 Offline_Uncorrectable 0x0030 200 200 000 Old_age
>> > > Offline - 0
>> > > 199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age
>> > > Always - 0
>> > > 200 Multi_Zone_Error_Rate 0x0008 200 200 000 Old_age
>> > > Offline - 0
>> > > 240 Head_Flying_Hours 0x0032 024 024 000 Old_age
>> > > Always - 55990
>> > > 241 Total_LBAs_Written 0x0032 200 200 000 Old_age
>> > > Always - 78243499218
>> > > 242 Total_LBAs_Read 0x0032 200 200 000 Old_age
>> > > Always - 174621575474
>> > >
>> > > SMART Error Log Version: 1
>> > > No Errors Logged
>> > >
>> > > SMART Self-test log structure revision number 1
>> > > Num Test_Description Status Remaining
>> > > LifeTime(hours) LBA_of_first_error
>> > > # 1 Short offline Completed without error 00% 14352
>> -
>> > > # 2 Short offline Completed without error 00% 0
>> -
>> > >
>> > > SMART Selective self-test log data structure revision number 1
>> > > SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
>> > > 1 0 0 Not_testing
>> > > 2 0 0 Not_testing
>> > > 3 0 0 Not_testing
>> > > 4 0 0 Not_testing
>> > > 5 0 0 Not_testing
>> > > Selective self-test flags (0x0):
>> > > After scanning selected spans, do NOT read-scan remainder of disk.
>> > > If Selective self-test is pending on power-up, resume after 0 minute
>> delay.
>> > >
>> > > Well, I am running glmark2, watch, and stress-ng for about (one round
>> > > of glmark2) with no freeze. all from live media
>> > > --
>> > > :-)~MIKE~(-:
>> > > ---------------------------------------------------
>> > > PLUG-discuss mailing list - PLUG-discuss at lists.phxlinux.org
>> > > To subscribe, unsubscribe, or to change your mail settings:
>> > > https://lists.phxlinux.org/mailman/listinfo/plug-discuss
>> >
>> > ---------------------------------------------------
>> > PLUG-discuss mailing list - PLUG-discuss at lists.phxlinux.org
>> > To subscribe, unsubscribe, or to change your mail settings:
>> > https://lists.phxlinux.org/mailman/listinfo/plug-discuss
>>
>>
>>
>> --
>> :-)~MIKE~(-:
>> ---------------------------------------------------
>> PLUG-discuss mailing list - PLUG-discuss at lists.phxlinux.org
>> To subscribe, unsubscribe, or to change your mail settings:
>> https://lists.phxlinux.org/mailman/listinfo/plug-discuss
>
>
>
> --
> A mouse trap, placed on top of your alarm clock, will prevent you from
> rolling over and going back to sleep after you hit the snooze button.
>
> Stephen
>
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss at lists.phxlinux.org
> To subscribe, unsubscribe, or to change your mail settings:
> https://lists.phxlinux.org/mailman/listinfo/plug-discuss
--
:-)~MIKE~(-:
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.phxlinux.org/pipermail/plug-discuss/attachments/20200716/1df40899/attachment.html>
More information about the PLUG-discuss
mailing list