Routing Question

[Bill Nash]

If eth0 has an address within the network you're assigning statically,
that route entry will already be in your routing table.

eth0      Link encap:Ethernet  HWaddr 00:A0:C9:DB:38:16
          inet addr:10.0.0.100  Bcast:10.0.0.255  Mask:255.255.255.0

billn@lotus:~$ route -n
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use
Iface
10.0.0.0        0.0.0.0         255.255.255.0   U     0      0        0
eth0

- billn


On Thu, 13 Mar 2003, George Gambill wrote:

> On a Linux work station I edited /etc/init.d/network and added at the bottom
> just before the last "exit 0", the following
>
> route add -net 192.168.100.0 netmask 255.255.255.0 dev eth0
>
> when I restart the network (/etc/init.d/network restart) I get the message
> "SIOCADDRT: File exists"
>
> It works but is there a better place to be doing this???
>
> Thanks
>
> George
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
> To subscribe, unsubscribe, or to change  you mail settings:
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
>