NIC

[jtannenba]

Ok, yes, I recompiled the tulip.c file that came on
the floppy with the card.
Same error.
No ifconfig does not show eth0
The messages file did not show an error.
the modprobe tulip.o said 'invalid irq'
and the documentation says what I have in
/proc/pci shows my pci mb setup is wrong?? It is
all automatic. (set to auto)????
Joe
--- Patrick Fleming <pfleming@infomagic.net> wrote:
> 
> Did you compile the tulip driver yourself? What does
> /var/log/messages
> indicate? Do you have the file
> /etc/sysconfig/network-scripts/ifcfg-eth0 ?
> 
> Patrick
> 
> On Mon, 15 Oct 2001, jtannenba wrote:
> 
> > Hi all,
> >
> > Finally got broadband and am getting off of a
> dialup
> > modem..
> >
> > Problem, have a Linksys lne100tx pci card and put
> it
> > in the box.  Windows works fine.
> >
> > My Redhat 6.1, however, found  a card but didn't
> > recognize what kind.
> >
> > I did the config asked by the Readme.txt file
> (uses
> > the
> > tulip.o driver), but when I go to activate eth0,
> > it says 'delaying eth0 initialization.'  I am out
> of
> > ideas.  An ifconfig does not show eth0 either.
> >
> > Joe
> >
> > =====
> > JT and NE Tannenbaum
> > jtannenba@yahoo.com
> > ________________________________________________
> > See http://PLUG.phoenix.az.us/navigator-mail.shtml
> if your mail doesn't post to the list quickly and
> you use Netscape to write mail.
> >
> > PLUG-discuss mailing list  - 
> PLUG-discuss@lists.PLUG.phoenix.az.us
> >
>
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
> >
> 
> ________________________________________________
> See http://PLUG.phoenix.az.us/navigator-mail.shtml
> if your mail doesn't post to the list quickly and
> you use Netscape to write mail.
> 
> PLUG-discuss mailing list  - 
> PLUG-discuss@lists.PLUG.phoenix.az.us
>
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss


=====
JT and NE Tannenbaum
jtannenba@yahoo.com