dhcp

[robert jorgenson]

okay another problem...once i startx i cant ping anything....not even my own NIC

robert jorgenson wrote:

> okay i dont know what i did but i woke up booted my computer and now it can ping the outside world...but now i have a new problem...for
> some reason i cant get a browser open. I click on netscape, the computer will sit there and do its thing and then it just stops...no
> netscape no error nothing. i tried mozilla to same thing.
>
> robert jorgenson wrote:
>
> > okay ifconfig works fine eth0 shows up and i have an ip but there is no /etc/sysconfig/network file. Not using a cisco router just the
> > qwest gateway box and a netgear hub
> >
> > Craig White wrote:
> >
> > > robert jorgenson wrote:
> > > >
> > > > okay i am running SuSE 7.2(FINALLY thanx gontran and EBo) and so far all
> > > > i have done is ran yast2 and setup the NIC and i ran the hostname/dns
> > > > utility and checked the box that said use dhcp to set the hostname. And
> > > > i tried pinging stuff starting with this computer which it is hooked up
> > > > to on a network and it worked...the i tried pinging the gateway that
> > > > qwesy gave us and that worked...but i cant get outside to the internet.
> > > > If anyone knows whats goin on and can help i would appreciate it MUCHO!
> > > > thanx
> > > >
> > > -----
> > > type ifconfig
> > >
> > > it should list something like...
> > >
> > > eth0      Link encap:Ethernet  HWaddr 00:E0:29:43:F9:07
> > >           inet addr:24.221.62.42  Bcast:24.221.62.255
> > > Mask:255.255.255.0
> > >           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
> > >           RX packets:410999 errors:0 dropped:0 overruns:0 frame:0
> > >           TX packets:344092 errors:0 dropped:0 overruns:0 carrier:0
> > >           collisions:16749
> > >           RX bytes:327112700 (311.9 Mb)  TX bytes:55661176 (53.0 Mb)
> > >
> > > lo        Link encap:Local Loopback
> > >           inet addr:127.0.0.1  Mask:255.0.0.0
> > >           EtherTalk Phase 2 addr:0/0
> > >           UP LOOPBACK RUNNING  MTU:16436  Metric:1
> > >           RX packets:103354 errors:0 dropped:0 overruns:0 frame:0
> > >           TX packets:103354 errors:0 dropped:0 overruns:0 carrier:0
> > >           collisions:0
> > >           RX bytes:48758734 (46.4 Mb)  TX bytes:48758734 (46.4 Mb)
> > >
> > > does eth0 show up?  have an address?
> > >
> > > then cat /etc/sysconfig/network
> > >
> > > it should look something like this...
> > >
> > > NETWORKING=yes
> > > HOSTNAME="hostname.isp.tld"
> > > GATEWAY=24.221.62.41
> > > GATEWAYDEV=eth0
> > >
> > > You need to have a gateway address and gateway device listed in this
> > > file so - if you are really a dhcpcd (or pump) client, these should be
> > > filled out automatically when you obtain an ip address.
> > >
> > > If you are using a Cisco 675/678 DSL modem using Qwest as ISP, then you
> > > would probably want to configure manually and forget about DHCP
> > > altogether...
> > >
> > > Qwest would normally configure the lan settings of a Cisco 675/678 with
> > > an ip address of 10.0.0.1 so you could simply change your settings as
> > > follows (manually configured)
> > >
> > > ip address 10.0.0.2
> > > subnet mask 255.255.255.0
> > > gateway address 10.0.0.1
> > > gateway device eth0
> > >
> > > /etc/resolv.conf (for phoenix area - Qwest ISP only)
> > >
> > > nameserver 206.80.192.1
> > > nameserver 204.147.80.5
> > > domain qwest.net
> > >
> > > Craig
> > > ________________________________________________
> > > See http://PLUG.phoenix.az.us/navigator-mail.shtml if your mail doesn't post to the list quickly and you use Netscape to write mail.
> > >
> > > PLUG-discuss mailing list  -  PLUG-discuss@lists.PLUG.phoenix.az.us
> > > http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
> >
> > ________________________________________________
> > See http://PLUG.phoenix.az.us/navigator-mail.shtml if your mail doesn't post to the list quickly and you use Netscape to write mail.
> >
> > PLUG-discuss mailing list  -  PLUG-discuss@lists.PLUG.phoenix.az.us
> > http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
>
> ________________________________________________
> See http://PLUG.phoenix.az.us/navigator-mail.shtml if your mail doesn't post to the list quickly and you use Netscape to write mail.
>
> PLUG-discuss mailing list  -  PLUG-discuss@lists.PLUG.phoenix.az.us
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss