Are you expecting digital output? With my audigy and even Live cards (that supported it), you had to enable the digital output signal. In windows it will be sometimes auto-set during installation. I think I had to use alsamixer to finally find it. So not sure if you are using alsa or something else.
Sincerely,
Judd Pickell
On 12/4/06, JD Austin <jd@twingeckos.com> wrote:
Check the mixer to see if the volume is muted.
I've seen this be the default for some sound cards.
JD
Clayton Stapleton wrote:
> Audigy2 works fine in Windows XP and the same computer as SuSE 10.1. So all the connections are working fine. The problem is that in SuSE
10.1 I get no soubd out of the speakers. Looked at the wave forms in Audacity and that show that the external input is reaching the Audigy2 card but it is not going to the speakers, which it does in Windows. Even tried the software output to the speakers with Audacity and still no go.
>
> Any suggestions with be appreciated!
>
> Thanks
> Clay
> ---------------------------------------------------
> PLUG-discuss mailing list -
PLUG-discuss@lists.plug.phoenix.az.us
> To subscribe, unsubscribe, or to change you mail settings:
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
>
---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss