Hows the temperature of your video card?  Does it have a fan on it? Brian On 7/16/20 1:41 PM, Michael via PLUG-discuss wrote: > > Might the problem still be the he > > On Thu, Jul 16, 2020 at 4:37 PM Stephen Partington via PLUG-discuss > > wrote: > > 68C under load is good. 80C+ idle is bad. > > > On Thu, Jul 16, 2020 at 12:35 PM Michael via PLUG-discuss > > wrote: > > lets get back to heat... last time I was running glx (with the > horse > and various other pictures) and watch, and stress ng the temp > was like > 68. I don't think that is too bad. > > On Thu, Jul 16, 2020 at 3:19 PM Brian Cluff via PLUG-discuss > > wrote: > > > > Looks like your drive probably isn't the problem. > > > > Brian Cluff > > > > On 7/16/20 11:54 AM, Michael via PLUG-discuss wrote: > > > On Thu, Jul 16, 2020 at 3:37 AM Brian Cluff via PLUG-discuss > > > > wrote: > > >> Also check the health of your hard drive with smartctl. > I've hard > > >> systems freeze on me because my hard drive was dying that > then appear to > > >> work again for a while after a reboot. Basically your > drive starts > > >> throwing errors and eventually the system remounts it as > read only and > > >> your system eventually freaks out and freezes because it > can't write to > > >> the drive anymore. > > > I sure hope this is the problem. It'll give me an excuse > to put an ssd > > > in the machine. > > > This is from live media boot. I'll see if I can freeze the > system > > > again.... it did when I tried it before but it hasn't > frozen for a > > > couple of days now. > > >   sudo smartctl --all /dev/sda > > > smartctl 7.1 2019-12-30 r5022 > [x86_64-linux-5.4.0-26-generic] (local build) > > > Copyright (C) 2002-19, Bruce Allen, Christian Franke, > www.smartmontools.org > > > > > > === START OF INFORMATION SECTION === > > > Model Family:     Western Digital Caviar Blue (SATA) > > > Device Model:     WDC WD3200AAKS-75L9A0 > > > Serial Number:    WD-WMAV2S110171 > > > LU WWN Device Id: 5 0014ee 057775228 > > > Firmware Version: 02.03E02 > > > User Capacity:    320,072,933,376 bytes [320 GB] > > > Sector Size:      512 bytes logical/physical > > > Device is:        In smartctl database [for details use: > -P show] > > > ATA Version is:   ATA8-ACS (minor revision not indicated) > > > SATA Version is:  SATA 2.5, 3.0 Gb/s > > > Local Time is:    Thu Jul 16 18:33:20 2020 UTC > > > SMART support is: Available - device has SMART capability. > > > SMART support is: Enabled > > > > > > === START OF READ SMART DATA SECTION === > > > SMART overall-health self-assessment test result: PASSED > > > > > > General SMART Values: > > > Offline data collection status:  (0x84) Offline data > collection activity > > >                      was suspended by an interrupting > command from host. > > >                      Auto Offline Data Collection: Enabled. > > > Self-test execution status:      (   0)    The previous > self-test > > > routine completed > > >                      without error or no self-test has ever > > >                      been run. > > > Total time to complete Offline > > > data collection:         ( 6000) seconds. > > > Offline data collection > > > capabilities:              (0x7b) SMART execute Offline > immediate. > > >                      Auto Offline data collection on/off > support. > > >                      Suspend Offline collection upon new > > >                      command. > > >                      Offline surface scan supported. > > >                      Self-test supported. > > >                      Conveyance Self-test supported. > > >                      Selective Self-test supported. > > > SMART capabilities:            (0x0003) Saves SMART data > before entering > > >                      power-saving mode. > > >                      Supports SMART auto save timer. > > > Error logging capability:        (0x01) Error logging > supported. > > >                      General Purpose Logging supported. > > > Short self-test routine > > > recommended polling time:      (   2) minutes. > > > Extended self-test routine > > > recommended polling time:      (  73) minutes. > > > Conveyance self-test routine > > > recommended polling time:      (   5) minutes. > > > SCT capabilities:            (0x3037)    SCT Status supported. > > >                      SCT Feature Control supported. > > >                      SCT Data Table supported. > > > > > > SMART Attributes Data Structure revision number: 16 > > > Vendor Specific SMART Attributes with Thresholds: > > > ID# ATTRIBUTE_NAME          FLAG     VALUE WORST THRESH TYPE > > > UPDATED  WHEN_FAILED RAW_VALUE > > >    1 Raw_Read_Error_Rate     0x002f   200  200   051    > Pre-fail > > > Always       -       0 > > >    3 Spin_Up_Time            0x0027   138  133   021    > Pre-fail > > > Always       -       4075 > > >    4 Start_Stop_Count        0x0032   089  089   000    > Old_age > > > Always       -       11090 > > >    5 Reallocated_Sector_Ct   0x0033   200  200   140    > Pre-fail > > > Always       -       0 > > >    7 Seek_Error_Rate         0x002e   100  253   000    > Old_age > > > Always       -       0 > > >    9 Power_On_Hours          0x0032   019  019   000    > Old_age > > > Always       -       59593 > > >   10 Spin_Retry_Count        0x0032   100  100   000    > Old_age > > > Always       -       0 > > >   11 Calibration_Retry_Count 0x0032   100  100   000    > Old_age > > > Always       -       0 > > >   12 Power_Cycle_Count       0x0032   098  098   000    > Old_age > > > Always       -       2282 > > > 192 Power-Off_Retract_Count 0x0032   199  199   000    Old_age > > > Always       -       1044 > > > 193 Load_Cycle_Count        0x0032   197  197   000    Old_age > > > Always       -       11090 > > > 194 Temperature_Celsius     0x0022   105  080   000    Old_age > > > Always       -       38 > > > 196 Reallocated_Event_Count 0x0032   200  200   000    Old_age > > > Always       -       0 > > > 197 Current_Pending_Sector  0x0032   200  200   000    Old_age > > > Always       -       0 > > > 198 Offline_Uncorrectable   0x0030   200  200   000    Old_age > > > Offline      -       0 > > > 199 UDMA_CRC_Error_Count    0x0032   200  200   000    Old_age > > > Always       -       0 > > > 200 Multi_Zone_Error_Rate   0x0008   200  200   000    Old_age > > > Offline      -       0 > > > 240 Head_Flying_Hours       0x0032   024  024   000    Old_age > > > Always       -       55990 > > > 241 Total_LBAs_Written      0x0032   200  200   000    Old_age > > > Always       -       78243499218 > > > 242 Total_LBAs_Read         0x0032   200  200   000    Old_age > > > Always       -       174621575474 > > > > > > SMART Error Log Version: 1 > > > No Errors Logged > > > > > > SMART Self-test log structure revision number 1 > > > Num  Test_Description    Status   Remaining > > > LifeTime(hours)  LBA_of_first_error > > > # 1  Short offline       Completed without error      >  00%     14352         - > > > # 2  Short offline       Completed without error      >  00%         0         - > > > > > > SMART Selective self-test log data structure revision number 1 > > >   SPAN  MIN_LBA  MAX_LBA  CURRENT_TEST_STATUS > > >      1        0        0  Not_testing > > >      2        0        0  Not_testing > > >      3        0        0  Not_testing > > >      4        0        0  Not_testing > > >      5        0        0  Not_testing > > > Selective self-test flags (0x0): > > >    After scanning selected spans, do NOT read-scan > remainder of disk. > > > If Selective self-test is pending on power-up, resume > after 0 minute delay. > > > > > > Well, I am running glmark2, watch, and stress-ng for about > (one round > > > of glmark2) with no freeze.  all from live media > > > -- > > > :-)~MIKE~(-: > > > --------------------------------------------------- > > > PLUG-discuss mailing list - > PLUG-discuss@lists.phxlinux.org > > > > To subscribe, unsubscribe, or to change your mail settings: > > > https://lists.phxlinux.org/mailman/listinfo/plug-discuss > > > > --------------------------------------------------- > > PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org > > > To subscribe, unsubscribe, or to change your mail settings: > > https://lists.phxlinux.org/mailman/listinfo/plug-discuss > > > > -- > :-)~MIKE~(-: > --------------------------------------------------- > PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org > > To subscribe, unsubscribe, or to change your mail settings: > https://lists.phxlinux.org/mailman/listinfo/plug-discuss > > > > -- > A mouse trap, placed on top of your alarm clock, will prevent you > from rolling over and going back to sleep after you hit the snooze > button. > > Stephen > > --------------------------------------------------- > PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org > > To subscribe, unsubscribe, or to change your mail settings: > https://lists.phxlinux.org/mailman/listinfo/plug-discuss > > -- > :-)~MIKE~(-: > > --------------------------------------------------- > PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org > To subscribe, unsubscribe, or to change your mail settings: > https://lists.phxlinux.org/mailman/listinfo/plug-discuss