It is most definitely 64 bit. I had 64 bit 16.04 running like a champ until the 18.04 upgrade was done. It also ran vmware 6.7 well also. On Mon, Dec 9, 2019, 9:02 PM Thomas Scott wrote: > I know I had a legacy install on a Proliant I supported that was installed > upside down and burnt out it's drives after a few years (surprised it > lasted that long). When I came on-site to reinstall it, I tried to install > 16.04 since I already had the install media on me, I couldn't as it had > issues with the RAID array controller. I had to roll back to 14.04 and then > upgrade it to maintain compatibility. I had a similar issue with CentOS6/7 > a bout a year ago as well, also on HP servers. In my experience, both times > it was the RAID controller. > > > Thomas Scott > about.me/thomas.scott > > > > > On Mon, Dec 9, 2019 at 9:47 PM Todd Cole wrote: > >> I suspect it may be 32Bit computer but it should give you a i386 hardware >> error during installation. >> while 18.04 is only 64 bit you can use the net install at >> http://cdimage.ubuntu.com/netboot/bionic/ >> it has a community supported 32 bit version available >> >> On Mon, Dec 9, 2019 at 12:24 PM Stephen Partington >> wrote: >> >>> I have an older Proliant server I am trying to make use of at home. The >>> hardware is fully functional, and aside from needing some spare drive >>> sleds, It is ready to go. >>> >>> However, I cannot run 18.04 on the server and I suspect it is related to >>> changes in the kernel and I am trying to map those. >>> >>> The Architecture is Dual Opteron quad-core Processors and DDR2 ECC >>> Registered memory. I think it is a DL 365 Gen 1 (would have to look to make >>> sure) >>> >>> Does anyone have thoughts on how I could gracefully get this hardware to >>> a current kernel? >>> >>> -- >>> A mouse trap, placed on top of your alarm clock, will prevent you from >>> rolling over and going back to sleep after you hit the snooze button. >>> >>> Stephen >>> >>> --------------------------------------------------- >>> PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org >>> To subscribe, unsubscribe, or to change your mail settings: >>> https://lists.phxlinux.org/mailman/listinfo/plug-discuss >> >> >> >> -- >> >> --------------------------------------------------- >> PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org >> To subscribe, unsubscribe, or to change your mail settings: >> https://lists.phxlinux.org/mailman/listinfo/plug-discuss > > --------------------------------------------------- > PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org > To subscribe, unsubscribe, or to change your mail settings: > https://lists.phxlinux.org/mailman/listinfo/plug-discuss