>>>> /dev/sdc1 on /media/bmike1/Seagate Expansion Drive1 type fuseblk >>>> bmike1@MikesBeast ~ $ ls -l /media/bmike1 >>>> drwxr-xr-x 3 root   root   4096 Sep 25 19:16 Seagate Expansion >>>> Drive >>>> drwxrwxrwx 1 bmike1 bmike1 4096 Sep 25 19:57 Seagate Expansion >>>> Drive1 >>> Have a good look at the ls -l output and the output from mount.  >>> This >>> is a problem people run into with automounters and sometimes >>> mounting by >>> device identifiers. > On Wed, Sep 26, 2018 at 8:34 PM Bob Elzer wrote: >> my guess would be you are not unmounting it correctly. if you yank it >> out before unmounting it, you could be interrupting some write >> operations. which could corrupt something. >> Questions would be are you unmounting before you remove it. On 2018-09-27 01:07, Michael wrote: > yes The way the problem is showing up makes me think it's the automounter doing something dumb. 2 directories in /media/bmike1 , one named with the filesystem label of the disk, one named that label+"1" is a classic programmer solution to the problem of having two filesystems with the same label present at the same time. Something somewhere forgot to clean up the old mountpoint, the automounter thinks the device is still there, and your backup fails because the device is mounted to a mountpoint that's not what you expect. So: Go in to whatever's doing your automounting, gnome-mount or whatever, and umount all the removable media devices it thinks are mounted. Unplug the disk. After that, there should be no directories in /media/bmike1/ . If there are, rmdir them. Then plug the disk back in. If you're lucky, the automounter will then put the disk on the right mountpoint. -- Crow202 Blog: http://crow202.org/wordpress There is no Darkness in Eternity But only Light too dim for us to see. --------------------------------------------------- PLUG-discuss mailing list - PLUG-discuss@lists.phxlinux.org To subscribe, unsubscribe, or to change your mail settings: http://lists.phxlinux.org/mailman/listinfo/plug-discuss