from all the arrays i have made that is a bit more complicated that it should be. but from my layout that has worked fro me in several flavors make sure the logical volumes that will be part of the array are the same size (not sure if this is a requirement but it has made life simpler) Make sure a /boot partition exists outside of the array, i have had some issues when this is not done. create the partitions and when it asks for type choose Linux raid from the partition manager. Then hit the raid manager and make your array and partition as needed On Sun, May 24, 2009 at 8:29 AM, Matthew A Coulliette wrote: > Hi all, > > Here is a link for setting up software raid for Ubuntu Server 9.04: > http://doc.ubuntu.com/ubuntu/serverguide/C/advanced-installation.html > > I followed the instructions carefully.  In fact, it took me several > tries to make sure I followed the instructions accurately.  The first 2 > sections were hard to follow, but once I understood what they meant the > directions made sense.  Here are the names of the first 3 sections of > the instructions and my comments: > > Partitioning: I created new partition tables and created my partitions. > RAID configuration: was slightly different than the instructions, but > seemed to work. > Formatting: I could not follow these instructions.  It would not let me > make changes to RAID1 device #0. > > Here is my current partition table: > RAID1 device #0 - 131.5mb software RAID device >                         #1   131.5mb      f      swap      swap > SCSI2 (0,0,0) (sda) -  120.0 GB ATA ST3120827AS >                         #1   primary   131.6   mb   k   raid >                         #2   primary   58.9   gb   k   raid >                         #3   primary   58.9   gb   k   raid >                         #4   primary   2.0   gb   k   raid > SCSI2 (0,1,0) (sdb) -  120.0 GB ATA ST3120827AS >                         #1   primary   131.6   mb   k   raid >                         #2   primary   58.9   gb   k   raid >                         #3   primary   58.9   gb   k   raid >                         #4   primary   2.0   gb   k   raid > > Can someone tell me where I am going wrong with this?  Any advice would > be helpful.  Thanks in advance. - MatthewMPP > > --------------------------------------------------- > PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us > To subscribe, unsubscribe, or to change your mail settings: > http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss > -- A mouse trap, placed on top of your alarm clock, will prevent you from rolling over and going back to sleep after you hit the snooze button. Stephen --------------------------------------------------- PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us To subscribe, unsubscribe, or to change your mail settings: http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss