Correction: the parm below is vga=773, reference
http://en.wikipedia.org/wiki/VESA_BIOS_Extensions#Linux_video_mode_numbers

RW
---------------------
On Sat, 2008-03-08 at 20:08 -0700, Richard Wilson wrote:
> All,
> 
> I have found an article that outlines more or less exactly what I want
> to do at http://www.tummy.com/Community/Articles/cryptoroot-f8/ -- it
> outlines how to install Fedora 8 with only an unencrypted /boot
> partition.  In the instructions though, it uses an option that can only
> be done using the graphic installer, which, so far, I haven't gotten to
> work.
> 
> In the installer I am editing the vmlinuz parms and adding "nohz=off
> nolapic" without those, the install on my Dell Latitude D810 hangs  when
> it says "running /sbin/loader".  With those parms it boots the install
> successfully but displays vertical gray bars right after it
> "successfully" starts the X server...
> 
> I tried adding "vga=733" to tell it to try a 1024x768 display, but that
> didn't work either.  I am using the flat panel built into the laptop
> with the ATI Radeon built-in video controller... I may have to switch to
> using a CRT for teh install.  
> 
> Fedora 8 runs fine on this hardware -- I had it up and running before I
> got ordered to encrypt (or be forced to run only Windows).  I used the
> text based installer last time.
> 
> Again, thanks in advance for any insights into this.
> 
> Richard Wilson
> ---------------------------------------------------------------------------
> On Sat, 2008-03-08 at 08:10 -0700, chip33az@netscape.net wrote:
> > Richard Wilson wrote:
> > > All,
> > >
> > > I am setting up my laptop to be as encrypted as possible, and I'm
> > > leaning towards using LUKS partitions to do the work.  Is it possible to
> > > only have an unencrypted /boot and have everything else encrypted?  From
> > > what I found on the 'net so far, that may not be possible.
> > >
> > > I have experimented with Truecrypt as well and that is a decent
> > > alternative.  Any opinions as to which is "better"?
> > >
> > > Any full disk encryption tools out there that are Linux compatible?
> > >
> > > Thanks in advance,
> > >
> > > Richard Wilson
> > > relw at mchsi dot com
> > >
> > > ---------------------------------------------------
> > > PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
> > > To subscribe, unsubscribe, or to change your mail settings:
> > > http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
> > >   
> > This is exactly what I did.  On my PC, I used Gutsy and on my laptop I 
> > used Etch.  I kind of flip-flop between the two.
> > 
> > If you use the Gutsy alternative disc, you can set up encryption.
> > 
> > What I typically do is have the /boot as ext3, then use the rest of the 
> > drive partitioned for encryption.  I then use LVM to break the partition 
> > into two sections, swap and root (I could do more).  I then install as 
> > usual.  Works great.
> > 
> > For my backup, I use a little thumb drive that was encrypted with 
> > TrueCrypt.  They have an installer for Ubuntu, but for Etch one has to 
> > compile it.  There are instructions in their forums about this.  Not too 
> > difficult.  I like their new front-end for it.
> > 
> >  From what I have heard the new Fedora 9 will over full drive encryption 
> > as well.
> > ---------------------------------------------------
> > PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
> > To subscribe, unsubscribe, or to change your mail settings:
> > http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
> 
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
> To subscribe, unsubscribe, or to change your mail settings:
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss

---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change your mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss