. Problem solved ... see solution recapped at the bottom. >> joe@actionline.com wrote: >> I have a Dell GX260 with Intel P-4 2-Gig processor, 512mb ram, >> 40-gig HD, and XP installed. After I booted from a Linux >> live CD and started to install, I defragged and then used >> Knoppix QTParted to resize the HD to 22-gig for XP and the >> remainder (about 16-gig) to be used to install Linux. >> However, when I tried to restart the computer to >> begin the installation, I have only a blank screen and cannot >> even get to the bios. I can't boot from HD, CD, or floppy. On Mon, 7 May 2007 09:49, Dazed_75 wrote > If the screen truly remains totally blank, it is virtually > always either power or a video problem. I work with those > models a lot and have seen this issue a few times before and > 99% of the time it is a simple thing. > > Make sure the video cable is not loose or plugged into the wrong > vga connector (like if you moved the machine). Many GX260's (like > the one to my left) have an independent video card and it is very > easy to plug into the main board vga by mistake. Or like the one > to my left, to plug into the wrong plug of the dual head video card. > > Check that the power indicator in the middle of the power switch > button remains green after power up. If not you might have a bad > PSU or (much les likely) switch or mainboard. If it does remain > green, look at the 4 diagnostic lights above the USB ports on the > back of the machine. If they are not all green, go to > http://support.dell.com/support/edocs/systems/opgx260/en/ug/solvprob.htm > for an interpretation. After much searching on the Internet, I learned that this is a known problem with this Dell computer and the solution is to unplug the computer (and if that doesn't work, to also remove and reinstall the battery and/or the memory chips), then the Dell will see the bios again. This may need to be done more than once. After several attempts, that finally worked. --------------------------------------------------- PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us To subscribe, unsubscribe, or to change you mail settings: http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss