FoulDragon@aol.com wrote:
> In a message dated 31.Aug.2006 23.39.29 US Mountain Standard Time, 
> lthielster@gmail.com writes:
> 
>> Today I replaced my old Linksys 802.11b wireless AP/router/4 port switch 
> with a Linksys >WRT54G (sorry, thought I had bought the GL but...).  I configured 
> it to use 128 bit WEP >instead of the 64 bit I had been using.
> 
> :looks at his own WRT54G setup page:
> 
> The 128-bit mode is really just 104-bit... it only accepts a 26-digit key.
> 
> -Did you set the router's 'incoming MAC filter'?  Maybe it's refusing your 
> card because you tightened the filter too tight.
> 
> -Maybe the software is set to seek out the 'easiest target' network... one of 
> my desktops used to keep trying to hook into a network several houses away, 
> with a 8% signal level, because it was unencrypted.
> 
> I know 802.11b can work... my WRT54G talks happily to my prehistoric (early 
> 2003) Belkin 802.11b PCMCIA card.
> 
> Does it work when the WEP is turned off?
> 
> And lastly, is it perhaps a reception thing?  I get *terrible* coverage out 
> of my WRT54G:  the PC in the same room gets 80-100%, but one wall/one 
> floor/about 10 metres away,. we're down to maybe 30 percent.

I had about 40% on a WRT54G going through a wall/floor at my former home. I 
built a couple reflectors for it out of cardboard, toothpicks, glue and 
aluminum foil and got about 10% improvement. Let me know if you'd like the 
web site where I got the plans (I'd have to hunt for it). You need a fairly 
precise arc for it to work properly/well.

-- 
-Eric 'shubes'
---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change  you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss