The bus speed on a P166 isn't fast enough to support a gig network card.
If I remember correctly it can barley support a 100M card. Even the
newer machines PCI bus will not support the full 1G from the cards, but
they do get very close though.



-----Original Message-----
From: plug-discuss-bounces@lists.plug.phoenix.az.us
[mailto:plug-discuss-bounces@lists.plug.phoenix.az.us] On Behalf Of Jim
Sent: Sunday, July 02, 2006 10:09 PM
To: plug-discuss@lists.plug.phoenix.az.us
Subject: Gigabit on a dinosaur?

Today I bought a couple of Trendnet TEG-PCITXR gigabit ethernet cards. 
I put one in my windows box and one in my linux box.  The linux box is a

dinosaur.  It's a P166 running slackware 10.2 2.4.31 kernel.  DMESG 
shows the card is correctly identified and shows the following:

eth1: Auto-negotiation Enabled.
eth1: 1000Mbps Full-duplex operation.

I watched iptraf as I copied a file from the windows box to the server. 
  Iptraf was showing the incoming rate on eth1 at around 28000
kbits/sec.

Should I be getting better speeds than this or is this all I can expect 
from my dinosaur.

Thanks

Jim in Phoenix
---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change  you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss

---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change  you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss