I ran ifup eth0 and got ERROR: No configuration found for ethO. I ran ifconfig again and same report as before was displayed. No problem, I don't know SuSE at all. Thanks, Dale McGarry -----Original Message----- From: plug-discuss-bounces@lists.plug.phoenix.az.us [mailto:plug-discuss-bounces@lists.plug.phoenix.az.us] On Behalf Of Craig White Sent: Saturday, August 06, 2005 6:36 PM To: Main PLUG discussion list Subject: RE: SuSE 9.0 Personal internet connection problem On Sat, 2005-08-06 at 18:31 -0700, Dale McGarry wrote: > Sorry about the HTML format. > > Here is what I see when I ran ifconfig: > > Link encap: Local Loopback > Inet addr: 127.0.00.1 Mask: 255.0.0.0 > Inet6addr: ::1/128 Scope: Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:50 errors:0 dropped:0 overruns:0 frame:0 > TX packets:50 errors:0 dropped:0 overruns:0 carrier:0 > Collisions:0 txqueue:0 > RX bytes:2608 (2.5 Kb) TX bytes:2608 (205Kb) > > However, when I ran cat/etc/resolv.conf this what was displayed: > bash: cat/etc/resolv.conf: No such file or directory > > No router, cable goes into external modem (Scientific Atlanta DPC 2100) and > runs to PC and, yes I have to power down the modem when I want to switch > computers. ---- OK - you don't have any ethernet interface active... try (as root) ifup eth0 and see what happens (try running 'ifconfig' command again to see if interface activates and gets an ip address) It's likely that YAST has a configuration panel to the network adaptors and can turn it on as well...I don't know SuSE well. Craig --------------------------------------------------- PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us To subscribe, unsubscribe, or to change you mail settings: http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss --------------------------------------------------- PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us To subscribe, unsubscribe, or to change you mail settings: http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss