Those commands I gave were for a fwbuilder scirpt

www.fwbuilder.org




Jim


I will what you suggested.






On Fri, 2004-02-27 at 12:22, Jeremy C. Reed wrote:
> On Fri, 27 Feb 2004 elemint@hotpop.com wrote:
> 
> > I have tried to add the below to my fw script but no go.  I want to port
> > forward all pop traffic from one server to another, any suggestions.
> 
> If using iptables, use something like:
> 
> iptables -t nat -A PREROUTING -i eth0 -p tcp --dport 110 -j DNAT \
> --to-destination 192.168.2.2
> 
> Where eth0 is your outside interface and 192.168.2.2 is the system that
> the POP3 traffic should go to.
> 
> > I placed this in my fs sciprt right above the ip_forward command
> >
> > src=any
> > dst=server server
> > srv=POP3
> > action=accept
> 
> I have no clue what above means. What script is that for? (What distro?
> What software?)
> 
> > echo 1 > /proc/sys/net/ipv4/ip_forward
> 
> This means your system will route packets. This is not address
> translation.
> 
>    Jeremy C. Reed
>    http://www.reedmedia.net/
> 
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
> To subscribe, unsubscribe, or to change  you mail settings:
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss

---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change  you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss