On Wed, 2004-02-25 at 15:09, elemint@hotpop.com wrote:
> I am trying to configure a flat panel Dell 17003FP monitor and according
> to the documentation the monitor supports 1280x1024  64.0 kHz and
> vertical 60.0 Hz or 1280x1024  Horiz 80 kHz and Vert 75 Hz
> 
> 
> 
> I was looking at the man page for XF86Config-4 and it says that usually
> a range is entered in the config file, could I just put 80 kHz for the
> Horiz and 75 Hz for the Vertical, or is a range required. 
> 
> 
> Of course those rates are only 1280x1024 which is the only resoltion I
> am using, but should I enter the rate range for all resolutions from as
> low to as high as the monitor supports under all resolutions supported?
---
I am not very skilled at xfree86 stuff but my flat panel (cheap), I
used...

        HorizSync    59.0 - 65.0
        VertRefresh  60.0 - 60.0

thus I entered 59.0-65.0 in the Horizontal and 60.0 in the vertical.

If I were you, I would probably put in 74.0 - 80.0 in the horizontal and
75.0 in the vertical - see what happens.

Craig

---------------------------------------------------
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change  you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss