Did you try sdb1? It looks like it should be sdb1. The number is the
partition, the number defines the
actual drive...

Also, make sure you have the right usb modules loaded.

I just got a Muvo and got it to work. I'm listening to it now. It rocks!


-marcia
On Mon, 10 Nov 2003, Jim wrote:

> ect:
> [Tfug] usb flash disc
> I have tried to get my usb flash disc to work by making edits to /etc/fstab and
> the problem is that I have not been able to determine where usb-storage is
> loading the usb flash disc in. For example /dev/sda2 could be the usb flash
> drive but I recieve the following error: /dev/sda2 is not a valid block
> device
>
>
>   When I cat /proc/scsi/scsi I have the below output:
>  cat /proc/scsi/scsi
> Attached devices:
> Host: scsi0 Channel: 00 Id: 03 Lun: 00
>   Vendor: PLEXTOR  Model: CD-ROM PX-40TS   Rev: 1.05
>   Type:   CD-ROM                           ANSI SCSI revision: 02
> Host: scsi0 Channel: 00 Id: 04 Lun: 00
>   Vendor: PLEXTOR  Model: CD-R   PX-W1210S Rev: 1.05
>   Type:   CD-ROM                           ANSI SCSI revision: 02
> Host: scsi2 Channel: 00 Id: 00 Lun: 00
>   Vendor: USB      Model: Flash Driver     Rev: 1.11
>   Type:   Direct-Access                    ANSI SCSI revision: 02
>
> When I run the following command when plugging in the flash disc "tail -f
> /var/log/messages" I recieve the following:
> kernel: usb.c: USB disconnect on device 00:07.3-1 address 2
> kernel: hub.c: new USB device 00:07.3-1, assigned address 3
>
>
>
>
> Jim
>
> ---------------------------------------------------
> PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
> To subscribe, unsubscribe, or to change  you mail settings:
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
>
>