I'm trying to install Red Hat 9 on a brand new system to be a 
file/print/db server. My problem is that as soon as the computer comes 
back up from the install, the screen goes blank except for a box that 
says "no signal". Red Hat identifies the video card as a n S3 ProSavage 
KM133. I installed Win XP just for a minute and it said the card was an 
S3 ProSavage DDR. In either event, according to this page 
<http://www.probo.com/~timr/savage40.html> the savage_drv.o should do 
the trick and Red Hat installed that.

If it's a clue, Red Hat wouldn't even complete the install without 
blanking the screen until I said "linux lowres" at the boot prompt. In 
that case the message on the screen said something about 'out of sync'.