I have a squid report that is generated with sarg and it usually works
fine although sometimes it does not and when it does not it usually puts
in thousands of userids instead of the few hundred that are there
normally there and then the few hundred that are normally there are not
there.  

Any suggestions?

I have also been googel'ing, asking the squid-users list and the sarg
list to no avial.  There were other users with the same problem on the
sarg list but no fix yet.   

sarg just runs against my access.log file should I remove sections of it
to see if it works with only parts of it?  

Otherwise does anyone else have any suggestions for creating reports for
internet access for particular IP addresses from an access.log file from
Squid?


Jim