I have my home desktop with a cdburner in it. I decided to install a scsi card and transfer the os to it. I mounted and copied the entire os over to the new scsi drive. Configured lilo and ran it. Removed the ide drive and was running on my new scsi drive. Everything was setup and working right until I tried to run cdrecord. I have the correct hdc=ide-scsi setup because it is the same as my ide hard drive setup. I tried putting hte ide drive back in and removeing the scsi card and it works fine. I have done some google searching and haven't been able to find anything out about scsi cards that give problems to ide-scsi drivers so I am completely at a loss. I am not new to setting up ide-scsi drives even on scsi systems. I have done it atleast 10 or 15 times before and this is the first time I have had a hangup like this. Anyone see anything like this before? any help you could give would be, well, helpful -- Bill Warner Direct Alliance