I did the modem off/on thing before the problem came up with RH.
Like I said, I had it working fine in XP.

-----Original Message-----
From: plug-discuss-admin@lists.plug.phoenix.az.us
[mailto:plug-discuss-admin@lists.plug.phoenix.az.us]On Behalf Of Craig
White
Sent: Thursday, September 12, 2002 10:14 PM
To: plug-discuss@lists.plug.phoenix.az.us
Subject: Re: New install NIC problem


On Thu, 2002-09-12 at 21:11, Mark Berkwitt wrote:
> I installed k12ltsp(Red Hat) today and since it's ltsp it set my nic
> "VT3043(Rhine)" to the local network.
> I've been using that nic for my cable modem connection. Since I have a
dual
> boot system now, I installed a second nic "DECchip 21041(Tulip Pass 3)" to
> now use for my internet connection for each OS.
> XP took it just fine, but RH was a different story.
> Upon booting it found the new hw and I right away checked the uhhh, you
> know, the auto thing since my isp provides ip's dynamically.
> Further into the boot it brought up the eth0 ok, but FAILED on eth1.
> How do I fix that?
-----
Cable modems lock into the MAC address of the NIC. If you attempt to
change NIC's, you must power the cable modem off for several minutes -
this will cause it to reset, reload it's configuration from the TFTP
servers on Cox's network and permit you to change NIC's.

I know of no other way to do this.

try ifconfig - what does it report?

look at /etc/sysconfig/network-scripts/ifcfg-eth1

does it look like... (I'm guessing at this because I don't use dhcp)

DEVICE='eth1'
BROADCAST=''
IPADDR=''
NETMASK=''
NETWORK=''
ONBOOT='yes'
BOOTPROTO='DHCP'

if so, try - ifup eth1

Craig
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us
To subscribe, unsubscribe, or to change  you mail settings:
http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss