I'm forwarding this as I originally sent it from an account not recoginzed by plug. If the modorator gets the first one please disregard it - message below ---------- Forwarded Message ---------- Content-Type: text/plain; charset="us-ascii" From: charlie bullen To: plug-discuss@lists.plug.phoenix.az.us Subject: K12 LTSP - Linux at Work Date: Mon, 29 Jul 2002 11:01:05 -0700 X-Mailer: KMail [version 1.4] MIME-Version: 1.0 Content-Transfer-Encoding: quoted-printable Message-Id: <200207291101.05025.charlie@swtravel.com> Status: RO X-Status: S Good Morning, this past weekend I took my Suse box that I have been using at work home and installed the K12LTSP software on it. I tried to get it to dual boot using lilo on my Suse install with no luck, but no big deal as I created a boot disk. eth0 configured to default settings, 192.168.0.254 subnet 255.255.255.0 etc. eth1 configured to ip for lan at work including default gateway and dns servers. I also took home one of the worst computers available, amd 333, 32megs ram, no hard drive. Put in a $9.99 nic, created a boot disk, connected to the K12LTSP server and fired up the box. IT picked up the IP address and booted off the server without a hitch. I could tell no difference in performance if I was working on the server itself, or the bad computer. Problems occured when I got this box to work. I connected to the lan using eth1 and tried to pull a web page - no results, I started trouble shooting by pinging eth0 and got fast response times, then I pinged the gateway on our lan and got respose times ranging from 2000 to 4500 ms with 10% packet loss. I then pinged our DNS server and got slightly worse respones times and about 30% packet loss. Tried pinging outside ip address and got even worse response times and greater packet loss. As I had to work, I gave up on k12LTSP for the time being, booted to Suse8.0 on this same box and got immediate web access, great response times and no packet loss. Any idea what would cause such poor results booting to K12LTSP, which by the way is a modified redhat 7.3 installation. I only have today and tomorrow to figure this out as I am going on vacation on wednesday for 1.5 weeks. I have a great opportunity as one of the programmers, who wants to try a linux workstation, is working real close to my workstation this week. He is using an old emachine, of the same model that I have gotten to work with K12LTSP on my home network. Any help would be appreciated. Charlie -------------------------------------------------------