needed sources and locations apache source www.apache.org mm source www.engelschall.com -- go to open sourced software mm will be listed OpenSSL www.openssl.org ModSSL www.modssl.org After building and installing mm & openssl I usually untar both sources SSL and APACHE then go into the ssl dir and use ./configure --with-apache=/use/src/apache-1.3.xx --with-ssl=/usr/src/openssl -0.9.x --enable-shared=ssl --with-mm=/usr/src/mm version source make make install then enter the apache source and do the following EAPI_MM="/usr/src/mm-source-dir" SSL_BASE="/usr/src/openssl-source-dir" ./configure --enable-module=most --enable-shared=max --enable-shared=ssl --e nable-module=ssl make make install then alls you have to do is create your SSL cert keys and do /location/of/your/installd/binary/apachectl startssl usually by default its /usr/local/apache/apachectl startssl if you dont get any errors your all good HTH Nige ----- Original Message ----- From: "Eric" To: "Plug-Discuss" Sent: Sunday, March 03, 2002 9:19 PM Subject: : apache ssl install > > > Hi, > > I'm following "Apache: the definitive guide," and I'm trying to install > apache 1.3.22 with ssl. The book says to > > i) build SSLeay (openssl), > ii) then exand the apache tar ball, > iii) then in the parent directory of apache, expand apache+ssl patch > iv) then do "./FixPatch". > > Fixpatch concludes by telling me to rebuild openssl again, but the book > clearly implies that this is not to be done. Rather, the book says to go on > and re-build apache. > > Has anyone done this lately? Do I need to rebuild SSL after building 5 > minutes ago? I'm using openssl 0.9.5a and apache_1.3.22+ssl_1.44.tar.gz. > > Eric > > ________________________________________________ > See http://PLUG.phoenix.az.us/navigator-mail.shtml if your mail doesn't post to the list quickly and you use Netscape to write mail. > > PLUG-discuss mailing list - PLUG-discuss@lists.plug.phoenix.az.us > http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss >