"Michael J. Schweppe" wrote:
> 
> On Wed, 25 Jul 2001 00:46:17 -0700, you wrote:
> 
> >Justin wrote:
> >>
> >> Reboot w/ a Linux boot disk and go into rescue mode, mount your drives and
> >> run /sbin/lilo -v -v
> >>
> >> -----Original Message-----
> >> From: plug-discuss-admin@lists.PLUG.phoenix.az.us
> >> [mailto:plug-discuss-admin@lists.PLUG.phoenix.az.us]On Behalf Of Michael
> >> J. Schweppe
> >> Sent: Tuesday, July 24, 2001 5:23 PM
> >> To: plug-discuss@lists.PLUG.phoenix.az.us
> >> Subject: Re: lilo failed--HELP
> >>
> >> On Tue, 24 Jul 2001 17:10:46 -0700 (PDT), Matt Alexander <m@netpro.to>
> >> wrote:
> >>
> >> >To restore the DOS MBR, type this at the command prompt:
> >> >
> >> >fdisk /mbr
> >> >
> >> I get the return of another A:\> with nothing.
> >>
> >----------
> >wow - I believe that when your /boot oartutuib is on the slave drive,
> >you have to include something like bios=0x82 in lilo.conf -  you should
> >have seen a message flash by about this at the tail end of the install.
> 
> Messages go by pretty fast, couldn't tell you...
> 
> To recap, on the initial install, after the second cd was placed I
> stepped out of the room for an extended period of time.  This was a
> mistake because I missed the boot creation section, apparently Linux
> timed out and finished the install.  Hence no boot disk on round one.
> 
> After I got the fdisk /mbr sqaured away [I didn't know that after you
> issue the fdisk /mbr commmand that noting happens on the command line
> but that you reboot anyhow.  OK, so I'm back in Win and reinstall Red
> Hat.  Careful to pay close attention and make boot disk.  Reboot.
> Blah.  Same issue :-(.  After reboot I get the usual power up stuff,
> and then a flashing "L" with a non-responsive system.
> 
> Use boot disk to get Linux up.
> 
> Here is a copy of my /etc/lilo.conf
> 
> boot=/dev/hda
> map=/boot/map
> install=/boot/boot.b
> prompt
> timeout=50
> message=/boot/message
> linear
> default=dos
> 
> image=/boot/vmlinux-2.4.2-2
>         label=linux
>         read-only
>         root=/dev/hdb8
> 
> other=/dev/hda1
>         optional
>         label=dos
> 
> Thanks,
> 
> Mike
> ________________________________________________

I still think that you need to try bios=0x82 - I believe that you can
try this from the lilo boot...i.e. - press control X when you see the
lilo picker - type 'linux bios=0x82' (less the single quotes) and see
what happens. If that does it then you can add that line to lilo.conf -
rerun lilo and you would have it made.

Craig