-----Original Message----- From: Bob George [mailto:plug@bobspc.dhs.org] Sent: Tuesday, July 17, 2001 8:21 PM To: plug-discuss@lists.PLUG.phoenix.az.us Subject: Re: Routing Question "Furmanek, Greg" wrote: > 2 Routable IP addresses on the same subnet: Your success may depend on your provider. If they expect to "see" your device's MAC, it might be tricky. Are you doing actual routing with your ISP? (I assume not) routing is done by the firewall. I do not think my ISP cares about the MAC address at all. Your firewall will need to respond to both addresses externally. Start there and see if that works. It'll help to be able to test from an external location. If it does, the rest is simple. That is another thing. How do I set up the firewall to respond to two addresses externally? A 1:1 NAT would do nicely for the DMZ network, 1:n for the inside network. You'll probably want DNS set up externally to be able to locate the two external addresses by name. I was thinking of 1:1 NAT for that CPU. - Bob ________________________________________________ See http://PLUG.phoenix.az.us/navigator-mail.shtml if your mail doesn't post to the list quickly and you use Netscape to write mail. PLUG-discuss mailing list - PLUG-discuss@lists.PLUG.phoenix.az.us http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss "The sender believes that this E-mail and any attachments were free of any virus, worm, Trojan horse, and/or malicious code when sent. This message and its attachments could have been infected during transmission. By reading the message and opening any attachments, the recipient accepts full responsibility for taking protective and remedial action about viruses and other defects. The sender's employer is not liable for any loss or damage arising in any way from this message or its attachments."