at the ok prompt enter "printenv boot-device" and verify the disk it's pointing to is the boot disk.. Don ---------- Original Message ---------------------------------- From: George Toft Reply-To: plug-discuss@lists.PLUG.phoenix.az.us Date: Thu, 22 Mar 2001 23:18:31 -0700 >I have a Sparc2 with Red Hat 5.2 installed. The hard drive is correctly identified if I type "probe-scsi" at the prom ok prompt, but it hangs when I try to boot from the drive. I suspect a bad drive. It spins up, prom identifies it, but the Red Hat installer won't read from it. I've set the jumper for termination, and that did nothing. I'm pretty scsi stupid (and sparc stupid), so I'm looking for some hints here. The box was a freebie, so I'm not complaining too much. The drive is a Micropolis 4421AV, which is fast scsi-2 narrow. Can I replace it with any fast scsi-2 50 pin drive and expect it to work? Thanks in advance for your help. George ________________________________________________ See http://PLUG.phoenix.az.us/navigator-mail.shtml if your mail doesn't post to the list quickly and you use Netscape to write mail. Plug-discuss mailing list - Plug-discuss@lists.PLUG.phoenix.az.us http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss