Just watch out for symmetry in your design that would create a loop and
subsequent broadcast storms.  Since only one of your switches is Cisco, I
don't know if spanning tree protocol will help you here.  I don't know too
much about your 3COM however.  Are you asking for more physical
connectivity?  Sorry if my response is useless to you.

- Joel
----- Original Message -----
From: "Mike Starke" <mgcon@neta.com>
To: <plug-discuss@lists.PLUG.phoenix.az.us>
Sent: Thursday, September 28, 2000 9:40 AM
Subject: off topic -> switching


> Hope I don't cause too much of a ruckus; but no one
> responded to my question yesterday, so I thought I would
> throw this simple one out:
>
> I have a new Cisco 2948 switch. I have a 3com 3300 switch
> that, for the most part, will be replaced by the cisco. The Hubs
> atr going down the road (retiring).  I would like to know
> how I connect the two switches?
>
> Mike
> mgcon@getnet.com
> http://www.getnet.com/~mgcon
> Phoenix, AZ
> USA
>
>
> ________________________________________________
> See http://PLUG.phoenix.az.us/navigator-mail.shtml if your mail doesn't
post to the list quickly and you use Netscape to write mail.
>
> Plug-discuss mailing list  -  Plug-discuss@lists.PLUG.phoenix.az.us
> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss