That depends on how the router is configured. I currently have the cisco external DSL router (675) configured with USWest as my ISP. It is running in bridging mode which means that the ROUTER has both an External IP (one that is visible to the net) and an internal ip (10.0.0.1 netmask 255.255.255.0). It acts as a DHCP server for all my boxes behind it. As such it is hooked directly into the Hub. With it in this configuration I have to edit the NAT inside the router to redirect traffic of certain types (tcp or udp) on certain ports to point to specific IP's and ports on an internal system. I currently have apache on one of my systems and have all port 80 tcp requests passed through the router to it. In routing mode the DSL router is a passive device and doesn't get an ip itself. The IP is given to a Computers NIC. In either case you will need to know how your network is layed out and determine the configurations of the router and the computer it is connected to. Rooster wrote: > > speaking of cisco routers, does anyone know how to go about accessing your > system when runnning dsl service via a cisco router? > > > > > Please make sure that if you are running Cisco Routers > > that you have set: > > ip no directed-broadcast > > on all of your interfaces. > > Also make sure that you are doing proper filtering outbound at > > your border router(s) to prevent source address spoofing > > _______________________________________________ > Plug-discuss mailing list - Plug-discuss@lists.PLUG.phoenix.az.us > http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss -- "Intel giveth and Microsoft Taketh Away" - Gordon Moore