correct way to set timezone & clock/date?

[Eric Shubert]

I thought that too at first. Then I saw that I have them in my config as 
well, so I'm guessing that's not a problem. It might be a good thing to 
get rid of them though.

Bob Elzer wrote:
> P.S. you might have to move the fudge line after your server lines.
> 
> IF you read the comments, 127.127 are radio and modem clocks and connect
> through serial or peripheral bus
> 
> So it looks like it was trying to connect to a local device, which I'm sure
> you don't have.
>  
> 
> 
> -----Original Message-----
> From: plug-discuss-bounces at lists.plug.phoenix.az.us
> [mailto:plug-discuss-bounces at lists.plug.phoenix.az.us] On Behalf Of Steven
> A. DuChene
> Sent: Tuesday, August 25, 2009 2:52 PM
> To: plug-discuss at lists.plug.phoenix.az.us
> Subject: Re: correct way to set timezone & clock/date?
> 
> OK, but why would I have the problem with ntpdate too? It does not use the
> ntp.conf file as far as I can tell. I think it is some sort of network
> problem but here is the ntp.conf file anyway.
> 
> 
> 
> -----Original Message-----
>> From: Eric Shubert <ejs at shubes.net>
>> Sent: Aug 25, 2009 5:03 PM
>> To: plug-discuss at lists.plug.phoenix.az.us
>> Subject: Re: correct way to set timezone & clock/date?
>>
>> Sounding to me like there might be a problem in your ntp.conf file.
>> Can we have a look at it?
>>
>> Steven A. DuChene wrote:
>>> And after each of those lines shown below is a line that says:
>>>
>>> addto_syslog: configuration of 148.167.132.200 failed
>>> addto_syslog: configuration of 66.27.60.10 failed
>>>
>>> Any ideas?
>>>
>>> I am going to google this and see if anything pops up.
>>> --
>>> Steve
> 
> 
> 


-- 
-Eric 'shubes'