SuSE 10.1 and Sound Blaster Audigy2 Value

[Clayton Stapleton]

Thank you. Found the problem. It was in the Volume Control. Had to go to Switches and activate "Audigy Analog/Digital Output Jack". Now sound is working fine.

Thanks
Clay

> -----Original Message-----
> From: pickell at gmail.com
> Sent: Mon, 4 Dec 2006 09:54:56 -0700
> To: plug-discuss at lists.plug.phoenix.az.us
> Subject: Re: SuSE 10.1 and Sound Blaster Audigy2 Value
> 
> Are you expecting digital output? With my audigy and even Live cards
> (that
> supported it), you had to enable the digital output signal. In windows it
> will be sometimes auto-set during installation. I think I had to use
> alsamixer to finally find it. So not sure if you are using alsa or
> something
> else.
> 
> Sincerely,
> Judd Pickell
> 
> On 12/4/06, JD Austin <jd at twingeckos.com> wrote:
>> 
>> Check the mixer to see if the volume is muted.
>> I've seen this be the default for some sound cards.
>> 
>> JD
>> 
>> Clayton Stapleton wrote:
>>> Audigy2 works fine in Windows XP and the same computer as SuSE 10.1. So
>> all the connections are working fine. The problem is that in SuSE 10.1 I
>> get no soubd out of the speakers. Looked at the wave forms in Audacity
>> and
>> that show that the external input is reaching the Audigy2 card but it is
>> not
>> going to the speakers, which it does in Windows. Even tried the software
>> output to the speakers with Audacity and still no go.
>>> 
>>> Any suggestions with be appreciated!
>>> 
>>> Thanks
>>> Clay
>>> ---------------------------------------------------
>>> PLUG-discuss mailing list - PLUG-discuss at lists.plug.phoenix.az.us
>>> To subscribe, unsubscribe, or to change  you mail settings:
>>> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
>>> 
>> ---------------------------------------------------
>> PLUG-discuss mailing list - PLUG-discuss at lists.plug.phoenix.az.us
>> To subscribe, unsubscribe, or to change  you mail settings:
>> http://lists.PLUG.phoenix.az.us/mailman/listinfo/plug-discuss
>>